Follow

Info: Seachem Reef Builder™ Dosing Instructions

BEGINNER: Use 3 g (1/2 level teaspoon) per 150 L (40 gallons) twice a week. Dissolve in at least 250 mL (1 cup) of freshwater. Check alkalinity every 2 weeks and adjust amount or frequency accordingly. For precise dosing, use the Seachem Digital Spoon Scale™.

ADVANCED: Check alkalinity, then follow addition regimen above until alkalinity is adjusted to 4–5 meq/L. Each 3 g/150 L will raise alkalinity by about 0.25 meq/L. Quantity or frequency can be adjusted, but do not exceed 12 g/150 L per day. Thereafter, use as required to maintain alkalinity.

EXPERT: After determining the alkalinity consumption rate, set up a continuous drip system. Use the following formula to determine how much to add to your top–off water: m=0.08va (m=grams to add to top off water, v=volume of tank in liters, a=amount to raise alkalinity in meq/L). For example, if you want to raise your alkalinity by 1 meq/L in a 200 liter tank, then you would add 0.08x200x1=16 g into the top–off water. [For reference: 1 gallon=3.8 liters, 6 g=1 teaspoon]. Notes: Use MultiTest:® Marine pH & Alkalinity to measure total alkalinity.

DO NOT OVERDOSE: Excess alkalinity may enhance the loss of calcium, magnesium, and strontium. Do not directly mix with any calcium, magnesium, or strontium supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.

Contains carbonate, bicarbonate, chloride, and sulfate salts of sodium, magnesium, calcium, strontium, and potassium. Each gram contains a minimum of 12 meq of alkalinity.

Reef Builder™ Dosing Tables

Standard Dose

Raises alkalinity by approximately 0.25 meq/L

Water Volume 1 qt / 1 L 1 gal / 4 L 10 gal / 40 L 40 gal / 200 L
Reef Builder™ Dose (g) 0.019 g 0.075 g 0.75 g 3 g
Reef Builder™ Dose (tsp) 1/320 tsp 1/80 tsp 1/8 tsp 1/2 tsp

 

Formula

Want a different result?  Here's how to calculate it:

NOTE:  MEQ/L IS NOT EQUAL TO dKH

If your test kit gives results in dKH, you will need to convert to meq/L before using this calculator.

50 ppm = 2.8 dKH = 1 meq/L

_____________________________________________________________

Dose in grams =

Your tank volume (gal)  x  the amount you want to raise your alkalinity (meq/L)   x  0.3

Do not increase your alkalinity by more than 1 meq/L in a single day

 

_____________________________________________________________

Dose in teaspoons =

Your tank volume (gal)  x  the amount you want to raise your alkalinity (meq/L)  x  0.05

Do not increase your alkalinity by more than meq/L in a single day

_____________________________________________________________

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.